4.4. Modifying the Cluster Configuration

To modify the cluster configuration (the cluster configuration file (/etc/cluster/cluster.conf), use the Cluster Configuration Tool. For more information about using the Cluster Configuration Tool, refer to Chapter 3 Installing and Configuring Red Hat Cluster Suite Software.

	Warning
	Do not manually edit the contents of the /etc/cluster/cluster.conf file without guidance from an authorized Red Hat representative or unless you fully understand the consequences of editing the /etc/cluster/cluster.conf file manually.

Important

Although the Cluster Configuration Tool provides a Quorum Votes parameter in the Properties dialog box of each cluster member, that parameter is intended only for use during initial cluster configuration. Furthermore, it is recommended that you retain the default Quorum Votes value of 1. For more information about using the Cluster Configuration Tool, refer to Chapter 3 Installing and Configuring Red Hat Cluster Suite Software.

To edit the cluster configuration file, click the Cluster Configuration tab in the cluster configuration GUI. Clicking the Cluster Configuration tab displays a graphical representation of the cluster configuration. Change the configuration file according the the following steps:

1. Make changes to cluster elements (for example, create a service).

2. Propagate the updated configuration file throughout the cluster by clicking Send to Cluster.

   Note

   The Cluster Configuration Tool does not display the Send to Cluster button if the cluster is new and has not been started yet, or if the node from which you are running the Cluster Configuration Tool is not a member of the cluster. If the Send to Cluster button is not displayed, you can still use the Cluster Configuration Tool; however, you cannot propagate the configuration. You can still save the configuration file. For information about using the Cluster Configuration Tool for a new cluster configuration, refer to Chapter 3 Installing and Configuring Red Hat Cluster Suite Software.

3. Clicking Send to Cluster causes a Warning dialog box to be displayed. Click Yes to save and propagate the configuration.

4. Clicking Yes causes an Information dialog box to be displayed, confirming that the current configuration has been propagated to the cluster. Click OK.

5. Click the Cluster Management tab and verify that the changes have been propagated to the cluster members.